Mint Jib Boom Rear End Fitting including metal fitting and screw

MADE IN THE USA

Stainless Steel fairlead used for main and jib sheets, sized to allow a z-hook to pass through the sheet hole.

Available for 11mm and 10mm booms used in the IOM (International One Meter) class and weighs less than 0.9g.

Laser cut from 316L (A4) Stainless steel plate before being hand reamed to remove sharp edges of the sheeting hole and then tumble polished to remove all burrs and imperfections.

Slide onto your boom and then apply a light crimp using pliers to secure it in position.

MADE IN THE USA

Stainless Steel Clew fitting used for mainsail and jib clews. 

Available for 11mm and 10mm booms used in the International One Meter (IOM) class and weigh under 1.2g each. 

Laser cut from 316L (A4) Stainless steel plate before being tumble polished to remove all burrs and imperfections.

Slide onto your boom and then apply a light crimp using pliers to secure it in position.

To attach the sail use a pair of pliers to gently bend the leg of the fitting forwards to create sufficient gap to feed the clew of the sail onto the fitting and then bend the leg back.