Mint Carbon Keel Fin including stainless hardware

Mint Carbon Covered Keel Bulb (Mint design)

Mint Carbon Rudder

Mint customized brushless waterproof winch servo (7.4V 28.0 kgf.cm, 0.36s/360°)

Drum included

Mint customized brushless waterproof rudder servo (7.4V 10.0 kgf.cm, 0.04s/60°).

Ball bearing gooseneck fitting for 11mm mast extrusion.

Comes with screws to install into mast. 

Round Gooseneck Boom Head for 11mm booms

Rigging screw. Single-end design, nickel-plated brass, M2 thread. Used on newer IOM designs such as the Viss, Proteus and others. 

MADE IN THE USA

Mast crane laser cut in 1.5mm stainless steel.

Suitable for all 3 IOM rigs and fits our masthead fitting

316 Stainless Steel Headstay Hook

IOM, EC12, Soling, etc 

15.3 mm x 7.3 mm

3D printed Mast Heel for 11.1mm Mast section, specifically designed to fit the Vickers boats

3D printed Mast Heel for 11.1mm Mast section, specifically designed for the 3D printed Proteus IOM. Can be made from PLA-CF (Carbon Fiber reinforced) or ABS. 

Mast Ram for your 11mm mast, specifically designed for the Proteus.   3D Printed parts fitted on 30mm M4 Stainless threaded rod

This part differs from our standard rams in that it is on a 4mm threaded shaft rather than the standard 3mm, and it does not include a Holder as the Proteus 3D print includes a 4mm hole for the Ram Shaft.

Modified 15 June 2026:   The thumb wheel is now fitted with a brass insert to improve the fit and usability of the Ram

The stainless steel shaft  fits through the moulded hole in the printed mid section of the hull and held captive by the knurled nut used to adjust the Ram.   The Ram clip lightly clips around the 11mm mast section holding the mast secure while you are rigging.

Product images are for reference only.   Printed parts black are PLA-CF (Carbon Fiber reenforced PLA) on Stainless Steel threaded rod

This part may fit other boats, but please note that it is designed specifically to fit the Proteus boats using the PJ Sails  PW15B (40mm) gooseneck fitting

6mm OD x 1.25mm ID x 3mm H

Used for Jib Pivot Connections as well as Backstay Connection on certain boats such as Proteus, K2, etc. 

Nickel-plated brass fitting used primarily to form secure deck attachment points or fairleads

M3.5 threaded shaft and 2.5mm radiused eyelet hole. 

Mint Masthead Plug inc Swivel

Mint Forestay Hook (3 pack)

Mint Shroud Hook (3 pack)

Mint shroud turnbuckles (2 pack).

Includes top & bottom parts.

Bottom part supplied with straight wire & rubber cover.

Mint Spreaders (2 pack)

Metal Rings (10 pack)

Bowsies (10 pack)

Plastic Trim Balls with hole (10 pack)

Mint Mastfoot Plug

Mint Gooseneck & Kicking Strap assembly including screws & sliding cover on main boom

Mint Boom Sheet Eye inc screws (4 pack)

Silicon O Ring (10 pack)

Mint Sheet Attachment inc grommet, metal insert, cord and ball

2 pack

Mint Metal Clew Hook (2 pack)

Mint Jib Boom Tack Fitting including screw